Installing Rolled Roofing Tips

Install a drip edge around the perimeter of the roof.

Installing rolled roofing tips.

The roll is unwound and laid on the site of the future installation. Cut the rolled roofing. For extra durability you may install roll roofing in two layers. The strips should always be horizontal.

For this heat up the gas burner and push it to the edge of the site where it will be fixed. Using a measuring tape measure 35 inches 89 cm up from. Mark a chalk line to identify the end of your first layer. To seal a plumbing vent spread roofing.

Before you start to fix it you must check its integrity. It not only protects the roof but it also protects the fascia. Do not use the eaves as a guide instead because they can be uneven. 10 easy steps for diy rolled roofing installation 1 spend some time cleaning the roof before beginning a rolled roofing installation project.

This aluminum flashing protects the edges of the roof sheathing from water. Plan so that no two butt joints are closer than 2 feet from each other. Position the first course so it overhangs the drip edges by about 1 4 inch and roll it out a. Apply roofing cement to the roof.

Install roll roofing measure 35 inches up from the eaves at several intervals along the roof and mark them. Here are a few tips that will help you in the process. Fix edge fabric roll. It is also advised to install a drip edge along the roof s edge.

Snap a chalk line as a guide for the first layer roofing. Drip edge or drip cap is either plastic or sheet metal. Install peel and stick roofing in a similar manner. Attach it to the valley with roofing nails spaced 6 inches apart about 3 4 inch from the edge.

How to do it attach first course. 2 like any other roof project you should start this one by addressing the valleys. Tips for installing roll roofing follow these tips to make sure your new roof goes down smoothly. It s best to install the roof when the roof when the temperature is above 45 degrees.

If you must install it when it s colder you will want to warm the roof rolls before you start. Installing the rolled roofing 1. Cut the sections of flashing with tin snips as needed and nail. Clean the roof area of any sticks or small stones as over time they may poke holes through the roll roofing material.

To install roll roofing you ll need to cut the material into long strips of the correct length for your roof and lay it flat. Use a trowel to scoop up the roofing cement. Install roll roofing when the temperature is at least 50 degrees fahrenheit to keep the material from cracking. How to apply roll roofing laying begins at the lowest point.

It also helps if you first install a layer of roofing felt.