How to install a pop up gutter drain.
Installing gutter pops.
Begin by installing a slip joint splice on each end of an inside corner fitting.
Firmly hit the top of the nails with a hammer to drive them into each point.
Then trim the first section of the gutter to length with tin snips.
Snap the sections together.
It s much easier to join sections on the ground than to work from the top of a ladder.
Secure it with eight pop rivets or sheet metal screws.
Wrap the aluminum strip tight around the underside of the gutter.
Project step by step 20 cutting the gutter.
Cut a triangular section from.
We provide a fully licensed plumber to do all your gutter.
Here are the steps to installing a pop up gutter drain system.
Snap a chalk line between the start and end of the gutter run.
Use a square and pencil to mark the gutter length and cut to the line.
Dig a hole underneath your gutter downspout and place a catch basin in the hole.
Slide the splices on as far as they ll go.
Locate the endpoints and hold a nail over each.
Hook one side of the chalk line to the nail at the start of the gutter run.