The scratch coat must be scored horizontally on vertical surfaces.
Install awning on stucco wall.
With stucco only the extra pressure from a good heavy rain would rip it out or the stucco only attachment.
Stucco installation labor basic basic labor to install stucco with favorable site conditions.
Two awnings installed on stucco wall.
Using the power drill fitted with a phillips head drill bit fasten the screws through the pilot holes in the stucco and into the wall stud until the fixture is secure.
Conventional stucco over wood should always be applied as a three coat system.
After installing the brackets the installation process of the awning can vary based on the awning itself as well as the type of mounting.
Install building paper metal lathe and three coat scratch brown and finish stucco.
Stucco itself does not have the strength to hold an awning and especially if you get any wind pressure on the awning which can be quite a bit.
You must attach the awning to the studs behind the stucco.
Many manufacturers utilize a mounting rail that attaches to the brackets.
Learn more and purchase at.
Scratch coat 3 8 inch thick brown coat 3 8 inch thick and finish coat 1 8 inch thick.
Thread the exterior grade screws through the item s hanging locations.
Includes planning equipment and material acquisition area preparation and protection setup and cleanup.
Products used in project.
Rolltec awnings is the leading canadian manufacturer of upscale retractable awnings.
Stucco installation over wood.
Keep in mind you can t rely on set screws to vary the awning level and plumb.
Doing so allows the awning housing to mount to the rail.
For stucco aluminum or vinyl siding it is recommended that a 1x4 board be screwed directly to the wall studs to carry the weight of the unit.
These can be purchased at any home center or lumberyard.