How To Install Wall Panels With Adhesive

Use a trowel and apply a 1 4 inch thick layer of frp adhesive to the back side of the first panel.

How to install wall panels with adhesive.

Cut it to fit the height of the wall apply a bead of silicone caulk down the entire length and press it into the inside corner. Apply adhesive with a caulk gun in a w or wave pattern. Place the panel on the wall and press it into the adhesive. Leave a millimeter space between each panel to allow for expansion and contraction as you stick them to the wall or frame.

Installing first panel on the wall with adhesive above 1 trim panel edge 1 so that it fits into the corner well and that edge 2 aligns with plumb line on stud if possible 2 drive four 3 penny 1 finishing nails 4 partway into panel 3 1 from the top edge. Custom engineered for installing parkland wall panels molding parkland panel adhesives can be used with porous non porous substrates. Load a caulking gun with a tube of panel adhesive and apply a small dab of it on the wall about every 10 inches. If the wall finish is at all glossy sand it with medium sandpaper.

Panel adhesive is available in tubs and tubes and can be applied with a notched trowel or a caulking gun. Plaster cement or mortar must be fully cured before wall adhesive is applied. Repeat until walls are covered. 1 cartridge adhesive for 4 decoflair wall panels.

To attach the paneling to the wall secure the paneling to the wall with panel adhesive and finishing nails. Tap in place with a rubber mallet. Align the panels and press them firmly until the glue adheres according to the adhesive manufacturer s recommendations. Apply 1 8x3 inch bands of adhesive to the wall frame or solid surface in a zigzag pattern.

Then lightly nail the tops so that they stay in position and pull the bottoms out and set them on a block of wood. Make sure the first panel is plumb to the wall. Scrape off any flaking paint or plaster. The rows of adhesive should be about 8 to 12.

This will ensure at least 60 percent of the back of each panel is covered. When using over cement or non porous surfaces please contact customer support at parkland plastics to discuss how to. Before starting to apply adhesive make sure that the existing wall surface is clean dry and sound. Press and hold each panel in place for 5 to 10 seconds and then let go.

Apply 1 4 inch continuous lines bead of adhesive every 3 to 4 inches across the back of your panel. Insert the panel into the corner moulding. In order to achieve an installation with uniform joints use between each panel tile crosses of 2 mm. Position and press the panel into place.