How To Install Metal Roofing On A Steep Roof

Add the metal panels.

How to install metal roofing on a steep roof.

Cut the shingles to fit around the flange s dome. Use your 1 1 4. Take your first sheet of. Be sure the larger edge is laid so that the small edge of the next panel will overlap it.

Try to space the screws about 12 inches apart down the entire piece of metal. Always begin working at the point with the longest peak to eave distance. A careful inspection will identify potential hazards and will give. The edging or eave flashing consists of metal strips that are used to cover the perimeter of the roof.

Some roofs are so high and so steep that even working from scaffolding can be dangerous. Preparing for a safe job on a steep metal roof requires an assessment of the roof before the job begins. To watch the entire series from the beginning click here. Adhere the joint where the cut edges of the shingles meet the dome with roofing tar.

Install the roofing screws vertically along each rib in the panel. Moreover try to ensure that the screws are all aligned evenly. A roofing harness provides the extra security you need when working on such a roof. If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof.

It isn t hard as long as you are careful take your time do it right and be safe. Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line.