How To Install Garage Door Rails

Attach the brackets for the cable to the bottom door panel following the manufacturer s instructions regarding the.

How to install garage door rails.

Garage door rails measure the distance between the track and the door and make adjustments if not equal on both sides. Also you will probably need someone to assist you because garage doors can be heavy. This old house general contractor tom silva shows how to assemble and hang a new garage door. Measure the garage door opening before purchasing panels.

Replacing the garage door track is not that difficult. To hold the level in place tape it to the section. Install the door panels. Placing the first panel and track 1.

Drill pilot holes image 1 and secure the bar with screws. Place the hinges. To hold the section in place lightly toenail a 16d nail into the frame and bend it over the section. Screw cable brackets to the door to secure the weather stripping.

See below for a shopping list and tools subscribe to this ol. However it is somewhat labor intensive and will take some time. Stand the bottom door panel on the floor in the garage doorway. Begin installing your new door.

Attach weather stripping to the bottom edge of garage door. How to install a garage door 1. Add brackets and rollers before setting them in place and stack one section on top of another toenailing as you go up. Install the weatherstripping onto the bottom edge of the bottom door panel.

Make sure the distance between the top of the door and the rail on both sides are equal. If the garage door track for your garage door is damaged it can prevent the door from properly opening and closing and will need to be replaced. At a home improvement store purchase some rubber weather stripping. Screws used to secure the vertical rails in place.

If you re installing a two car garage door place a reinforcing bar on the top panel to prevent the door from bowing in the center. Lay weather stripping over the bottom door panel. Slide one of the vertical rails on the wound. Be sure the bar is centered on the panel.

Use a tape measure to carefully record the length and width.