To install the doors install the track on the top of the door s frame.
How to install a sliding closet door pull.
Mark the location for the door pull.
This assumes you have a solid core pocket door.
Drill a shallow hole in the center drive a screw into the hole far enough to get a grip on the pull two complete turns at least grab the screw with a pair of pliers and pull it out.
The normal height for hardware on an 8 foot door is 36 inches from the bottom side up.
If you have a hollow core door then you will need to locate the wood block in the door and install the pull in that block.
Carefully use a small standard screwdriver to go around and slowly pry the pull off.
If that doesn t work at least now you may have enough to grab with the pliers without the screw.
Either way let us know how it s going.
Then latch the wheels on top of the door onto the back runner of the top track.
Step 1 position the pull.
Use a small standard screwdriver and finish hammer to remove the small nails.
Hold the door so the top is tilted backward.
Step 2 trace the template.
Mark the measurement with the edge of another piece of masking tape so that.
The task is easier if you predrill the holes and use a drill bit on the drill to secure the screws.
The runner is what the wheels roll along so the door can slide back and forth.