How To Hammer A Nail Into A Concrete Wall

Remove any concrete dust then press the anchor into the hole until it is flush with the surface.

How to hammer a nail into a concrete wall.

Reposition the board over the pilot holes aligning the board with the marks on the floor. Masonry nails should penetrate the surface of the concrete wall to a depth of 3 4 to 1 inch for a solid hold. Insert concrete or masonry nails into the holes and drive them flush to the surface of the wood using a framing hammer. Masonry nails are hardened and have grooved shafts and flat heads.

Https amzn to 2oq1m52 i cover a lot more than just how to use it. Be careful not to bend the nails as you drive them. The plastic hook attaches to the wall with small metal nails that pound into the wall surface with a hammer. Use at least a two pound hammer.

Tip 2 the correct hammer. Insert the concrete screw into the anchor and drive into the wall until secure. Drive the masonry nails directly into concrete walls with a hammer. A mash hammer also known as a masonry hammer as a double sided hammer that s much heavier than standard hammers making it the best choice to drive nails into concrete.

Hardwall hangers are picture hooks intended specifically for difficult surfaces like concrete block and brick walls. With your nail held in place against the wall tap the end of it with your hammer to drive the nail just enough so it s held in place in the wall and you don t need to. These hooks can support up to 25 pounds and can be pried from the wall when they are no longer needed. If necessary tap in lightly with a hammer.

A heavy hammer will give the right amount of power and leverage behind it and create the exact force needed for the nail to penetrate the concrete. This video shows you how to do it without bending the nail. Proper masonry nails or concrete nail are specifically designed to withstand the pressure of being hammered into a hard set surface.