Depending on the door handle design the faceplate may be able to slide completely off.
How to get door handle off that has no screws.
Many door knobs have trim plates that cover the screws so removing them can be a bit tricky if you ve never done it before.
Look for the tiny gap on the side of the door knob.
If you don t see a notch and the cover plate is round try turning the plate counterclockwise to remove it.
There should be a small latch near the base of the knob or handle probably on the exterior side of the door.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
Straighten a paper clip and insert it into the hole.
If not rotate the faceplate until the underlying screws are accessible and use a phillips head screwdriver to remove them.
You would be surprised how a simple job like removing a door handle or doorknob can be a frustrating experience if your not prepared.
The door handle will now slide off.
Next find a small slot on the edge of the trim piece.
How to remove a door knob without screws or a latch.
With some pressure you can move the clip inside.
Once triggered the lever or lock trim can be removed from the door.
Remove door knob without screws.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
Push this latch in and pull the handle off the door.
To remove a door handle without any visible screws start by prying off the cover plate by inserting a flathead screwdriver in the notch on the side of the plate.
If the knob has a recessed setscrew turn the setscrew counterclockwise with a correctly sized.
After applying some pressure you can pull the door knob towards you.
Insert the tip of a screwdriver and pry off the trim piece.
Our quick video shows you how si.
This is a simple straig.
Push the tip of a narrow screwdriver into the hole.
After you ve unscrewed or loosened the latch tug on the door knob until it pops out of place or disengages from the base also known as the rose.
That s because modern door hardware uses a hidden mechanism called a detent to fasten the doorknob that can only be released using a small screwdriver tip or the end of a paper clip depending on your style of hardware.
Slide the cosmetic faceplate away from the door.
Take your flat philips screwdriver and place it in the gap.